Blender animation stickman

Continue reading below

The requirements have been a stick-man moving in a precise way, with a particular motion blur.

First of all the stick-man has been sculptured, and added the required an emissive material.


Once finished the blender sculpturing phase, the armature has been added. The armature is very easy, because the required movement is very easy. At this point, it is time to start the animation of the  stick-man, at some precise frames the whole sticky-man keyframes added, to accomplish the required movement. Also the motion blur has been added.

It is time to set-up the blender animation, setting the output parameters and so on..

Below you can see the results!

[email-subscribers-form id=”2″]


Subscribe now and you will be updated for any news about the IoT word

Leave a Reply

Your email address will not be published. Required fields are marked *

Elisabetta Cataldi

© Copyright 2023 - All Rights Reserved
It was a pleasure see you there, we will see again